Home  |  About Us  |  Contact Us
 
Bison Panel >> Bison - Working With  
 
Working with Bison is like working with any other particle board
Fastening is done in the same way as any other boards.
No special tools are required. However for large volumes of cutting work electric hand saw is recommended.
Similarly hand held electric drill will be faster to work.
FIXING POINTS
 

FIXING

Bison Panel can be fixed to timber or steel supports. Thin cold rolled steel sections in the form of studs, tracks etc. are available in the market. They can be used with advantage for applications like partitions, false ceilings, flooring etc.
SUPPORTS
In applications, the board should be supported on all four edges and joints. The recommended span between support is 610mm.
FIXING
Thick-ness
Edge distance
Spacing
Inter-mediate
6-12mm
12 to 15mm
200mm
400mm
16mm
20mm
300mm
500mm
20mm
20mm
400mm
600mm
25mm & above
Equal to thickness
600mm
600mm
   
Fixing can be done with screws. A pre-hole shall be provided in the Panel before screwing. The length of the screw shall be 2 to 2½ times the thickness of the board.
The fixing point has to be 15mm (minimum) away from the edge of the board. Similarly the fixing point shall be 40mm away from the corner of the board.
 
All Rights Reserved@vrajenterpriseindia.com Designed & Developed By Pushpak Consultancy